Easy Fluted Arch Plant Stand (2 Ways!)
I recently came across an arched plant stand that I loved, but I just couldn’t do the $70 price tag. I thought it would be fun to make my own and use the supplies to make a few stand at once for a fraction of the cost.
For this DIY, I’m using small foam wreaths since they are inexpensive, easy to cut (I used a bread knife) and they are able to be glued together and painted. These fluted arch plant stands take minutes to put together, but the result is really fun and trendy as well.
You can see that there are two ways you can make the stand—either horizontally fluted (which is super easy and fast) or arched, which just takes a little more time (but is totally worth it).
Supplies:
-foam wreath rings (I used this 8″ size)
-super glue or hot glue gun
-wood circles a little smaller than your wreath rings (I used these 7″ circles)
-painter’s tape (optional)
-small craft hand saw or bread knife
-spray paint or acrylic paint of your choice
Horizontally Fluted Stand: To make the horizontally fluted stand, all you have to do is glue several foam rings together for the base. I did two but you could do more than that to make it taller.
Once they are attached, glue your wooden circle centered on top and you’re ready to paint!
Arched plant stand: For this one, you’ll want to glue your rings together like for the other planter, but then you cut the donuts in half with a serrated bread knife or a craft saw.
You can put some painter’s tape around where you are going to cut to keep the edges from getting ragged as you saw. Doing it this way gives you two bases for stands. If you just want one, you can cut a ring in half and then glue the two halves together.
Once your donuts are cut in half, use your knife or saw again to cut off the rounded tip of your half circle (cut about 1″ off) so that your wooden circle top has a flat place to sit.
Once you have your base cut, center and glue on your wooden circle for the top and allow the glue to set.
Once your glue is dry for your bases, you can paint your stands! You can either use spray paint or acrylic paint for this. I did notice that spray paint tends to enhance the snakeskin-like texture of the foam more than acrylic paint being brushed on does, but I like the textured look so I used spray paint for mine.
Once your paint is dry, add your plant and your stand is ready to get to work!
